Grease Monkey Approved Glass Fuse Inline Holder Featuring Real 12 Gauge Wire Leads That Brings Bad Ass Surge Blocking Power To Custom Rides And Worksites All Day Long
✔️ 12 awg leads, 30 amp rated, fits standard glass fuses, sleek frame
This inline fuse holder shields your wiring from nasty current spikes and short circuits. You mount it straight onto the positive cable run of trucks, boats, and shop equipment. The built in cables let you splice into existing layouts without buying extra terminal lugs. Standard cartridges are not included.
✅ 12 gauge copper wire leads conduct power steadily under tough loads ✅ Measures 1/4 inch by 1 1/4 inch for tidy panel mounting options ✅ Handles up to 30 amps of continuous current without melting ✅ Accepts common AGC style glass fuses for fast circuit replacement ✅ Built for rugged commercial fleets and hot rod electrical upgrades💡 What is the proper way to mount an inline fuse block for protecting custom vehicle wiring?
Install this handy protector near your main power source to stop dead shorts from frying expensive controllers. You want the housing sitting flush against a rigid bracket near the battery box. Just follow these simple steps to keep your rig running smooth.
- Strip about half an inch of insulation off the bare ends and twist tightly before sliding them deep into the brass clamps
- Wrap the plastic case in electrical tape or route it through split loom to dodge heat from headers and abrasive bed liner
- Match the fuse rating to your gear peak draw so normal operation never trips the breaker while fixing bad faults instantly
- Double screw the retention bolts before flipping the breaker so vibration never loosens the connection on dirt tracks