Swap The Busted Mount For This Top Tier Drive Shaft Center Support For 1986 Gmc K2500 Cuts Down Dreadful Drivetrain Vibration And Keeps Your Whip Rolling Smooth Daily
Buy Single Pack Driveshaft Mount For 86 GMC K2500
✔️ A6038 driveshaft bearing mount fits 1986 GMC K2500 V8 truck smoothly
This single pack drive shaft center support acts as a sturdy pivot point for your rear driveline assembly. You typically install it underneath the chassis frame rails to tame nasty shudders that creep through the floorboards during daily acceleration. It handles heavy torque loads while keeping the transmission output aligned with the rear differential gear.
✅ Part and pack: A6038, 1 piece✅ Vehicle fit: 1986 GMC K2500 with 6.2L V8 engine
✅ Mount position: Designed for direct OEM bracket replacement
✅ Fitment note: Requires Spicer U-Joint Series 1410-1480
✅ Driveline spec: Matches MRC Driveline tolerances for factory smoothness
✅ Retail pricing: $39.32 current online market rate
💡 What is a driveline center support bearing used for on classic pickup trucks?
This handy component isolates frame twist from rotating drive shafts to stop nasty floorboard vibrations.
Picking the right bushing stiffness keeps your axle tracking straight without wrecking gas mileage.
- Check the spline tooth wear and inner race gap before pulling out old crossmember bolts
- Slide the slip yoke until it bottoms out gently against the transmission output seal
- Coat every threaded stud with anti seize spray so nobody gets stuck stripping the holes next season