Tough As Nails Drive Shaft Center Support For 1987 GMC G2500 Dead On Fit Bearing Assembly Zero Headache Replacement To Quiet Drivetrain Whining And Keep Your Heavy Duty Pickup Running Smooth For Years
✔️ Single pack A6038 mount installs on 1987 GMC G2500 V8 setups
This handy drive shaft center support replaces busted cushions to lock your rear driveline in place on heavy duty rigs. It bolts right under the driveshaft to kill that rattling vibration, quiet whining noises, and keep your rig rolling smooth through work days and weekend trips.
✅ Part number A6038 includes one complete cushion mount assembly ✅ Engineered for 1987 GMC G2500 models equipped with a six point two liter V8 motor ✅ Compatible with MRC drivelines and Spicer U joint series fourteen ten through one four eight zero ✅ Ships at the standard retail value of thirty nine dollars and thirty two cents💡 What causes premature failure in driveshaft center pillow block bearings on heavy trucks? Swapping out a dried-out rubber cushion restores proper driveline angles and stops painful vibration patterns from wrecking your differential seals. Here is how to get it dialed in right:
- aligning the new mount with the factory crossmember holes locks the pinion angle back to spec
- pressing in fresh bushings eliminates metal-on-metal contact that destroys transfer case output shafts
- double checking the u joint yoke depth prevents binding when the rear axle compresses over bumps