Garage Ready 30 Ton Hydraulic Gear Puller With Hard Carry Case Adjustable Two Or Three Jaw Bearing Extractor To Knock Out Rusty Flywheel And Hub Bushings Without Hurry

Professional Grade Hydraulic Pulling System
✔️ 30 Ton Capacity Swivel Pump Solid Steel Jaws Heavy Duty Kit

This single pack hydraulic gear puller acts as a straight shooter bearing extractor built to knock out stubborn flywheels, hub sleeves, and drive pulleys without scratching adjacent metal. Local shop crews and weekend wrenchers lean on this exact unit to strip seized components off tractors, pickups, and workshop drills. The slim frame swings easy over an engine block while pumping out steady withdrawal force for tough jobs.

✅ 30 Ton maximum draw blasts through heavy rust adhesion ✅ Configurable two or three jaw setup fits different gear profiles ✅ 360 degree swivel pump head lines up perfect with odd angles ✅ Upright or flat positioning covers every bench orientation ✅ Built pressure relief valve shields the cylinder from sudden spikes ✅ Slide out throw punch taps loose inner races straight off the shaft ✅ Measured 35 cm reach and 70 mm throw stroke clears standard hubs

💡 What determines the right hydraulic bearing puller capacity for shop repairs?
You should size your tool around worst case corrosion instead of light assembly tasks.
- A handy rotating pump design saves your knuckles during heavy pulling cycles
- Match jaw tooth pitch to flywheel edges so the clamp bites tight under load
- Check overall frame width so the bracket misses nearby exhaust pipes safely
- Cover the pump tip between runs to keep the internal O ring fresh for years

✝️