Rear Engine Torque Strut Mount For 2010 Ford Flex Straight Up Direct Replacement Drivetrain Support Bracket Quiets Engine Vibes No Sweat Quick Garage Install

Direct Fit Rear Engine Torque Strut Bracket
✔️ Single pack fits 2010 Ford Flex 3.5L V6 rear mount specs

This handy drivetrain support piece anchors the rear engine bay to catch torsional shakes and keep the transaxle locked in place. Weekender mechanics and neighborhood wrenches slide it in to banish rattles that pop up during hard launches or heavy hauling. The single bracket drops right over the factory bolt holes so you can beat home to the driveway without chasing down parts.

✅ Part number A5425 built for straight swap installations
✅ Includes one steel bracket sized for independent mount jobs
✅ Sits behind the oil pan to steady the driveshaft rotation angle
✅ Fits twenty ten Ford Flex frames with the three point five liter V six motor
✅ Takes daily highway miles and sudden throttle snaps without letting go

💡 How do you properly seat a rear engine torque strut mount assembly on a ford flex?
Getting the new hardware aligned right takes a little elbow grease but saves money down the road.
- Align the stamped tab holes with the crossmember bosses before threading the main fasteners hand tight so the bracket rests flush without twisting the oil pan.
- Coat the steel studs with copper based grease and wrench them to spec while cradling the block with a transmission jack to stop any cross threads from ruining the threads.
- Verify the isolation boot clears the catalytic converter heat shield and snug the hardware in a cross sequence to kill that nasty shudder when you step on the gas.

✝️