Quick Swap Drive Shaft Center Support For 1967 Ford Econoline One Piece Oe Style Drivetrain Carrier Bracket Straight Install Ditches Drivetrain Shudder Smooth Highway Cruising Guaranteed

1967 Ford Econoline drivetrain center support bearing unit
✔️ A6038 single unit fits 1967 Ford Econoline L6 motor setups perfectly

This replacement drive shaft center support bearing stabilizes your rear axle assembly and keeps the drivetrain aligned during normal highway driving or daily commutes. It reduces shudders and vibrations that usually show up when original rubber mounts wear out over time.

✅ Part number A6038 guarantees exact OEM compatibility for your truck
✅ Single package contains one fully assembled carrier bracket ready for bolt-on installation
✅ Built specifically for 1967 Ford Econoline models equipped with the 3.9 liter inline six cylinder engine
✅ Compatible with standard Cleveland O55 U-joint configurations and MRC driveline assemblies for hassle-free swaps

💡 When does replacing a drive shaft center support bearing actually fix a shimmy in the floor boards?

Pulling a handy replacement component stops the oscillation and aligns the rear wheels with the front transfer case.
- Snug the factory style bracket bolts until the urethane sleeves compress evenly around the steel studs
- Double check the pinion angle against the stock measurements so the U joints bend at the correct arc
- Grease the slip yoke thoroughly before sliding the rear half back into place to prevent early wear
- Slam it in gear and roll down the open road to feel how quiet the whole drivetrain runs again