Rear Automatic Transmission Mount Bushing For 1996 Ford Contour Heavy Duty Steel Replacement Part A2887 Straight Bolt On To Tame Drivetrain Shake And Keep Your Sunday Cruises Smooth

A2887 Rear Transmission Bushing Fits Ford Contour (1 Pack)
✔️ Single pack heavy duty steel trans bushing fits Ford Contour

This direct fit unit replaces a worn out drivetrain support bracket to reduce shudder and stabilize gear shifts under load. It bolts straight onto the underside of the transmission case to manage everyday torque movement and keep the engine bay quiet during highway runs.

✅ Part ID: A2887 heavy duty steel construction
✅ Fitment target: 1996 Ford Contour automatic transmissions
✅ Installation route: Straight bolt on bracket alignment
✅ Performance fix: Cuts drivetrain shudder and vibration
✅ Package size: One individual replacement piece

💡 What are the exact signs that a rear automatic transmission mount bushing needs an early swap?
Pull the floor jack under the oil pan when you hear clunking during gear changes or feel excessive shudder at idle. This handy direct-fit hardware pins the case back in factory alignment and stops torque windup.
- Match the original bolt spacing to keep the starter ring gears from rubbing
- Tighten the main suspension crossmember nuts since old brackets shift chassis geometry
- Apply anti-seize compound to the threaded studs so next teardown clears without damage
- Inspect the inner cushion rubber because torn sleeves dump raw vibration into the cabin