Smooth Driving Drive Shaft Center Support For 1989 Ford E-250 Econoline With Slick Snap Fit Mount Delivers Straight Up Rock Solid Performance And Makes Quick Work Of Any Garage Swap

Heavy duty replacement driveshaft mount bracket for Ford vans
✔️ A6038 unit mounts to rear tubes while damping harsh vibration spikes

This single pack A6038 drive shaft center support acts as a sturdy pivot point for your powertrain. The assembly reduces road shudder and keeps the propeller tube balanced whether you are cruising interstate highways or hauling heavy cargo loads around town.

✅ Part number A6038 shipped as one complete mounting kit
✅ Direct installation slot fits 1989 Ford E-250 Econoline bodies perfectly
✅ Built for 5.8 liter V8 motors paired with Cleveland O55 U-Joint axles
✅ Slips right into MRC Driveline housings without extra fabrication work

💡 How do I lock out drivetrain vibration caused by worn center bearings?

Fresh rubber isolators grip the frame stiffly and kill shimmy without any guesswork. Drop these checks in your service log before you roll.

- Measure the input spline count and housing diameter to verify direct fit
- Align the gasket surface squarely against the transmission extension snout
- Tighten every crossmount fastener until torque wrench clicks steady
- Keep the alignment tool handy while routing the propeller shaft back

✝️