Straight Swap Drive Shaft Center Support For 1995 Ford F250 Rear Drivetrain Bearing Assembly OEM Style Fix That Nabs Bad Wobbles And Keeps Your Rig Rolling Sweet On Rough Dirt Roads

Rear Driveshaft Center Support for 1995 Ford F250 Trucks
✔️ 1 piece replacement unit fits 1995 Ford heavy duty rigs

This 1 piece A6038 rear driveshaft middle bearing assembly bolts straight into your frame to take the place of a busted factory unit. Drivers typically drop this right in when the transfer case starts howling and the cab feels every pebble. It cuts the wheel hop cold and gets your four by four back to hard-nosed towing without spending a fortune at the shop.

✅ Fits 1995 Ford F-250 with 7.5L V8 engine and Cleveland O55 U joint setup
✅ Replaces OEM style vibration control mounts to stabilize the rear drivetrain
✅ Direct swap design lines up with factory bracket bolts without extra fabrication
✅ Comes as a 1 piece set ready for immediate undercarriage overhaul

💡 What does a rear driveshaft center support bearing actually do for a heavy duty truck?
Swapping this handy little mount pulls the stress off your transmission and keeps the cardan joints spinning nice and true.
- The rubber isolator eats up the shock loads so the front prop won’t slap the frame rails next time you haul out
- Squaring the bracket holes stops that annoying shimmy by locking the middle bearing dead center inside the tunnel

✝️