Smooth Out Those Rear End Vibes With This Oe Style Drive Shaft Center Support Mount Keeps Your 1988 Ford Econoline Club Wagon Drivetrain Tight Sweet And Ready To Roll Garage Must Have

Replacement Drive Shaft Center Support For Ford Econoline
✔️ A6038 1 Pack Replaces 1988 Ford E150 Club Wagon Mount

This drive shaft center support mount stabilizes the rear axle assembly and cuts down on driveline rumble during typical street cruising. Local shops usually grab this handy replacement when factory rubber hubs degrade or bent brackets throw off the angle. Packed as a single unit, it brings back that tight feel and shields your U joints from early failure.

✅ Part number A6038 includes one preassembled drive shaft mount
✅ Direct replacement for 1988 Ford E150 Econoline Club Wagon
✅ Designed for 5.8L V8 engines with Cleveland O55 universal joints
✅ Compatible with MRC Driveline configurations and rear mounts

💡 How do you properly size a rear driveshaft support bracket?

A reliable fix requires matching the aluminum housing diameter to your transmission output spline. Check these handy setup steps before bolting it down:

- Track the flange bolt pattern and confirm the new spacer clears the exhaust heat shield

- Inspect the rubber isolator rebound rate to ensure proper torque isolation

- Compare the carrier bearing preload specifications against the factory service manual

✝️