Extension Featherboards For Table Saw And Router Table Kickback Eraser That Grips Your Lumber Dead Solid With Adjustable Plastic Slider For Flat Out Safe Woodworking Cuts Pack Of 2 Yellow
✔️ Dual clamp arms, 6.3 inch slide, rigid polymer, yellow color, pack of 2
This pack of two extension featherboards acts as a steady hand when you are running stock through power tools. The flexible fingers press your material firmly against the fence while the saw blade or router bit makes its pass. Workshop builders rely on this setup for table saw rip cuts, crosscuts, and routing operations along the fence line. You get matching yellow plates ready to mount straight out of the box.
✅ Measured at 6.3 inches of extension for wider stock clearance✅ Slides along a split rail miter rod to fit T track or 3/8 gauge slots
✅ Uses an internal spring loaded hinge that keeps constant downward pressure
✅ Built from tough ABS resin that resists wear, impact, and wood pitch buildup
✅ Ships complete with yellow locking plates, four grip handles, plus mounting screws and spacers
💡 What technique keeps a board from drifting off line or kicking back over sharp cutter heads?
Clamping a spring loaded featherboard to your fence takes the jitters out of rough cuts and keeps your knuckles clear of spinning blades.
- Steady lateral force pins the sheet goods flat against the track so accuracy stays on point
- Slide the bracket into standard gauge slots or T channels to adjust stance in seconds
- Loaded compression springs hold firm tension even when you shove dense maple or pine through fast
- Flip the unit face forward for pull pressure or reverse it to act as a top pin when stacking thin strips