Drop Dead Solid M8 Index Plunger Positioning Pin Spring Loaded Locating Stud With Threaded Base Stainless Steel Heavy Duty Hardware Built Tough For Shop Builds And Precision Jigs

Single Unit Stainless Steel M8 Index Pin For Bench Jigs
✔️ M8 x 1 thread, internal spring return, stainless outer shell

This is a single M8 index plunger built for tight tolerances and repeated clamping cycles in workshop environments. You typically mount it on jigs, fixtures, or CNC setup boards to dial in repeatable stop positions without guesswork.

✅ M8 metric threading for secure bolt-down mounting
✅ Internal compression spring provides positive detent feedback
✅ Stainless outer barrel pairs with a hardened carbon steel tip for wear resistance
✅ Single unit sold ready to install with standard washers

💡 What steps keep indexing pins from slipping during heavy machining?
Using solid backing plates and proper preload makes this fixture handy for busy shop floors.
- Screw the threaded base flush against your plate to kill any wiggle room mid-cut.
- Keep the contact faces clean so the spring load clicks into place every single pass.
- Pop in a fresh cartridge tip once you see side wear to lock position without any hassle.