Crown Molding Cuts Made Super Easy With This Solid Miter Saw Jig Dialed Dead Nuts On 38 45 And 52 Degree Angles For Quick Swap Of 2 To 5.5 Inch Trim No Sweat Rigging Built For Weekend Builders Wanting Flawless Joints Daily
✔️ Single piece jig holds 2 to 5 inch trim Sets exact spring angles
This single unit crown cutting fixture positions trim vertically so you avoid the usual upside down wrestling match on the table. Weekend builders and pros alike use it to slice wall profiles with zero geometry guessing since the material stays flat against the base during every pass. Just lock your preferred spring angle, seat the molding, and push the twelve inch sliding saw forward for a clean break.
✅ Adjustable collar matches 38, 45 and 52 degree factory spring standards✅ Accepts crown stock measuring two to five and a half inches tall
✅ Includes brass angle finders for rapid room measurement verification
✅ Recessed face board accommodates tricky dentil style decorative edges
✅ Collapsing arm frames fold completely flat for neat garage shelving
💡 What is the most reliable method for cutting crown molding spring angles accurately A dedicated right side up fixture acts as a handy tool for aligning three dimensional profiles against a flat saw table during operation. - Match the adjustment dial to common thirty eight forty five or fifty two degree factory springs - Guide the blade teeth straight along the recessed rail to handle decorative dentil grooves cleanly - Brace the loose base firmly against a workbench edge to absorb lateral kickback forces - Shift the fence height until the clearance cuts thicker casing profiles without wobble
✝️