No Sweat Direct Fit Drive Shaft Center Support For 1979 Chevrolet K20 Trucks Featuring Crush Resistant Bushings And Street Ready Build Quality For Smooth Highway Cruising And Trustworthy Drivetrain Control
✔️ Single A6038 unit installs cleanly to fix driveline wobble safely
A solid drive shaft center bearing like the A6038 keeps powertrain components tightly coupled while soaking up vibration during highway cruising. Built specifically for 1979 Chevrolet K20 rigs, this handy upgrade pairs perfectly with stock 6.6L V8 motors and Spicer U-joint series 1410-1480 configurations. Each package delivers 1 piece so you can ditch the cracked rubber and roll smoother than ever.
✅ Heavy duty elastomer bushing absorbs harsh road shock effectively✅ Factory matching bracket geometry bolts straight into chassis rails
✅ Compatible with 6.6L V8 drivetrains and Spicer U-joint series 1410-1480 setups
Where can automotive technicians source replacement driveshaft support cushions for routine service jobs?
💡 Grabbing the exact replacement stops premature driveline tears dead, so matching the original measurements avoids frustrating returns later.
- Loosen the housing fasteners while supporting the propeller shaft so no weight hangs off the damaged cushion.
- Wipe the carrier sleeve spotless, clearing grit or dried gasket residue so metal-to-metal contact stays tight.
- Press the new bearing squarely into the cast sleeve until the outer ring seats fully against the machined groove.
- Torque every fastener incrementally to spec while spinning the axle by hand to guarantee zero binding.
✝️