Built Tough Zinc Alloy Self Aligning Ball Bearing Pillow Block For Heavy Equipment And Motor Mounts Works Like A Charm With 35mm Bore And Rust Resistant Finish

Durable zinc alloy pillow block for motor shaft mounting
✔️ UP007 frame features 35mm bore and 150mm inner runner length

This solid bearing seat cuts friction while supporting radial forces on pumps and drive shafts.

✅ UP007 zinc casing sheds moisture and guards against surface corrosion
✅ 35mm bore fits 1.4 inch shafts while holding heavy rotational loads
✅ Unit spans 150mm overall length with 4.6 inch base span
✅ Each pack holds one ready to mount roller carriage

💡 What causes early failure in sealed pillow block bearing setups?
Dirt jamming past the edge seal destroys the rolling tracks fast.
- Hardened steel rings take constant grinding without wearing thin
- Grease locks stay put while pushing out wet shop debris
- Handy mounting slots line up with standard workshop brackets easily
- Zinc shells drop heat quicker than cast iron during big runs