Built Tough Steel Dock Board 60 X 72 Inch 16000 Lb Rated Capacity Forklift Transfer Plate Smoothly Covering Dock To Truck Height Shifts Up To 7 Inches For Quick Load Outs And Easy Handling

Heavy Duty Steel Dock Plate For Truck Transfers
✔️ 72 width 60 length, 16k pound capacity, 7 inch gap cover

This single reinforced steel transfer plate safely bridges the uneven gap between a warehouse apron and a moving trailer. Logistics teams rely on it daily at shipping docks to route forklifts, pallet jacks, and hand carts across tight height shifts without halting outbound freight movement.

✅ Measures seventy two by sixty inches for wide equipment clearance
✅ Handles sixteen thousand pounds for heavy machinery routing
✅ Adjusts over seven inch height differences during unloading runs
✅ Includes flip up lifting eyes for quick forklift positioning
✅ Features raised edge curbs that keep rolling stock from sliding off
✅ Sports a bright safety yellow finish for clear visibility in low light

💡 What is the best practice for securing a dock transition plate when truck suspension bounce changes the ground plane mid shift?
To keep your loading crew productive and your gear protected, using a handy setup routine prevents costly downtime and keeps heavy tires rolling smooth over these industrial moving surfaces.
- Anchor the front lip flush against the trailer bed rails before dropping any fork loads onto the center span
- Match the plate length to your largest pallet jack footprint to avoid suspension sag when crossing the middle joint
- Scan the underside stabilization bars for level contact with the concrete apron so the whole frame stays locked flat during peak hour rush

✝️