Built Tough Cast Iron Welding Rotary Turntable Workbench With Foot Switch Portable Desktop Positioner Holds Up To Twenty Two Pounds Like A Champ Quick Setup Smooth Motor Spin

Heavy Duty Cast Iron Welding Rotary Turntable Bench
✔️ 10W DC24V Motor Runs At 10rpm Handles 22lbs Load Capacity

This desktop welding rotary turntable plugs right into any shop and beats hand turning when you are prepping seams or tack welding. You get one solid unit out of the box that clamps tight and spins smooth so your joints line up perfectly. The heavy base stops chatter while you work through tight corners.

✅ Table surface measures 180 by 180 millimeters and 7.09 by 7.09 inches for middle sized projects
✅ Angle tilts smoothly from zero up to ninety degrees for flat or edge welding access
✅ Chuck grips rods between 2 to 58 millimeters or 0.079 to 2.28 inches securely
✅ Total unit weighs nine point eight three kilograms and forty six point four ounces for stable floor sitting
✅ Power cord plugs straight into standard american wall outlets at one hundred ten volts

💡 How do i actually set up a stationary work rotating jig for precise seam joining?
- Plug the hundred ten volt cord into a grounded outlet and stomp the foot pedal to wake up the low rpm drive gear
- Slide your stock through the self centering collar until it knocks solid against the back stop
- Twist the feed control dial until the spindle drags along at your desired pace without skipping
- Keep this handy rotary positioning table parked next to your torch so you can track complex beads faster than guessing angles