Ball Joint Holder For Fabbed Control Arms With Five Eighths Inch Male Right Hand Thread And Three Eighths Inch Hole To Accept Screw In Ball Joints And Clevis Holders Sold Separately

Ball Joint Holder for Fabbed Arms: 5/8 RH, 3/8 Hole
✔️ 5/8" male RH thread, 3/8" hole for screw-in ball joints - sold separately

These ball joint holders are designed for fabricators making custom control arms. They’re commonly used in DIY suspension setups where screw-in ball joints and clevis hardware are installed as a mounting solution.

✅ 5/8 inch male right-hand thread
✅ 3/8 inch hole to accept screw-in ball joints and clevis holders
✅ Designed for fabbed control arms
✅ Package dimensions: 22.86 L x 3.048 H x 13.97 W cm

💡 What is a ball joint holder used for in fabbed control arms?

This handy device is used to mount screw-in ball joints to DIY control arms, aiding alignment and serviceability.

- fabbed control arms mounting hardware
- 5/8 inch male RH thread compatibility
- clevis holders sold separately for complete setups
✝️