Badass Hot Dipped Galvanized Dock Washer Plates 10 Pack 1.5 By 5 Inches 6mm Thick Rock Hard Marine Boat Decking Hardware With Half Inch Holes For Floating Platforms And Stationary Rigging
✔️ Pack of ten 6mm hot dipped galvanized marine washer plates
These heavy duty steel spreaders distribute weight and keep fasteners from pulling through wood or composite surfaces. Boaters and builders slap these brackets onto floating docks boat lifts and stationary rigging frames to handle heavy loads without bending or sagging. Built to take daily pounding in freshwater docks, they hold their ground when tides shift or waves crash against pontoons.
✅ Hot dipped Q235 steel shell fights salt air and fresh water rust✅ Half inch corner holes drill right into wood or composite decking
✅ Six millimeter plate thick equals zero point two four inches solid depth
✅ One point five by five inch surface converts to thirty eight by one hundred twenty seven mm
✅ Quick mount setup works smooth with standard pipe leg holders and brackets
💡 How does hot dipped galvanized steel compare to standard painted coatings for heavy duty marina hardware projects
Skipping the thermal zinc bath ruins how fast your hardware holds up in wet conditions.
- The melting zinc creates a chemical bond that locks onto the metal core instead of just sitting on top of thin paint layers
- This thicker barrier stays handy when tightening bolts on floating walkways or securing anchor chains that drag across sandy bottoms
- Real marine grade plating handles swing loads and vibration shock without flaking away like cheap coatings do during peak summer heat
- You save cash down the road because the protected steel base stops corrosion dead in its tracks without monthly touch ups