6011-2RS NR Bearing with Rubber Shields C3 Snap Ring 55x90x18
Type: Deep groove Ball Bearing
Dimensions: 55mm x 90mm x 18mm/Metric
Radial Clearance: C3
ID (inner diameter)/Bore: 55mm
|6011-2RS NR Bearing|
With Snap Ring (C clip)
and Rubber Shields
55mm x 90mm x 18mm
6011-2RS NR Bearing with rubber shields and Snap Ring, The 6011-2RS NR inner diameter is 55mm, outer diameter is 90mm, and width is 18mm.
Deep Groove ball bearings are the most popular of all the ball bearing types because they are available in a wide variety of seal, shield and snap-ring arrangements. The bearing ring grooves are circular arcs made slightly larger than the radius of the ball. The balls make point contact with the raceways (elliptical contact when loaded). The inner ring shoulders are of equal height (as the outer ring shoulders). Deep Groove ball bearings can sustain radial, axial, or composite loads and because of simple design, this bearing type can be produced to provide both high-running accuracy and high-speed operation. Deep Groove ball bearings having an outside diameter less than 9 mm are known as Miniature ball bearings. Deep Groove ball bearings having an outside diameter => 9 mm and a bore diameter < 10 mm are known as Extra-small ball bearings. Standard ball retainers (cages) are made from pressed steel. Machined cages are used in bearing operating at very high speed or for large diameter bearings. Deep groove ball bearings with seals or shields are standardized. They contain proper amount of grease in advance.