16 Ton Manual Hydraulic Pipe Bender With Eight Included Dies For Copper Tubing And Steel Piping. Heavy Duty 45 Steel Frame Design Ensures Durability Under Any Condition Perfect For Electrical Construction Highway Projects Repair Work Boiler Assembly
✔️ 16 ton load, eight dies, adjustable rollers, precise bends.
This single-unit manual pipe shaping rig is built for electrical crews and construction professionals who need consistent bends on active sites. You are gonna use it for laying water lines, sizing conduit, or putting together boiler components without wrestling with gas-powered pumps. The heavy frame supports rough daily hauling while keeping cut costs low on stubborn metal runs.
✅ 16-ton dead load lifts thick stock with a 5.12 inch (130 mm) lever travel✅ Eight cast dies handle full sizes from 1/2 to 3 inch pipes (13 to 76 mm diameters)
✅ Six position guide tracks switch between 13 inch and 18 inch heights (330 to 460 mm vertical gap)
✅ Clean arcs deliver exact turns in the 90 to 180 degree range (1.3 to 7.6 cm swing width)
💡 How do I maintain precise alignment on a heavy manual hydraulic pipe bender during repeated conduit cutting tasks?
Swapping into this handy metal shaping station removes the headache from professional wire pull and plumbing grid setups.
- Dial your desired roller notch before applying downward pressure so the primary shaft remains locked center during operation
- Secure the rubberized drive knob to meter internal flow because steady compression beats rapid cycling every single time
- Cycle through multiple tight angles in one session since consistent leverage preserves curvature accuracy across long hauls
- Rotate fresh die cartridges when transitioning between flexible copper feed cables and hardened steel raceways on active builds