12 Inch Press Brake Attachment Fits 12 To 20 Ton Hydraulic Shop Presses Heavy Duty Metal Bending Beast For Sheet Forming And Fabrication Gear With Precision V Block Setup Blue

Single 12inch hydraulic press brake for shop metal forming
✔️ Mounts on 12-20 ton presses, bends 3/16 inch steel smoothly

This single pack press brake attachment is a stationary metal bending tool engineered to bolt straight onto standard hydraulic shop frames. Workshop operators install it to fold sheet metal, flat bar, and light channel stock into crisp corners without purchasing separate bending machinery.

✅ Built from 45# carbon steel featuring a blackened resin finish for lasting rust defense
✅ Delivers clean 90 degree folds across a full 12 inch working span
✅ Handles flat gauge stock up to 3/16 inch thick without frame deflection
✅ Compact dimensions measure 14.5 by 7.5 by 9.25 inches for clean bench setups
✅ Ships pre-assembled and ready to bolt directly onto your hydraulic press

💡 What drives buyers to choose a dedicated benchtop press brake attachment over universal jigs? Investing in a handy metal forming upgrade delivers consistent angle accuracy while protecting costly hydraulic rams from wear. This heavy duty unit stays rock solid because its reinforced steel body absorbs impact forces without warping over time.
- The precision vblock nose guides material placement for repeatable bend radii every shift
- A low profile base distributes clamping pressure evenly to stop thin sheet rocking
- Standard threaded holes match common shop press tie rod spacing for fast tool changes