10-Pack Bearings 6005ZZ 25x47x12mm - Shielded Deep Groove Ball Bearings
UPC: 00193019027134
Type: Deep Groove Ball Bearing
Material: Chrome Steel
Type: Ball Bearings
Closures: Metal Shields
6005ZZ Deep Groove Ball Bearings 25x47x12mm 10 Pack
✔️ Double Metal Shielded Chrome Steel Bearings
This 10 pack of 6005ZZ deep groove ball bearings is built for smooth rotation in motors, conveyors, pumps, and general machinery. Made from high-strength chrome steel and fitted with double metal shields, these bearings stay protected from dust while delivering steady, low-friction performance right out of the box.
✅ Pack size: 10 bearings
✅ Deep groove radial ball bearing design
✅ Inner diameter: 25mm
✅ Outer diameter: 47mm
✅ Width: 12mm
✅ Chrome steel construction for durability
✅ Double metal shields for contamination protection
✅ Pre-lubricated with grease
✅ Dynamic load rating: 10,100 N
✅ Static load rating: 5,850 N
✅ Grease limiting speed: 15,000 RPM
Dimensions Table:
Inner Diameter (ID) Outer Diameter (OD) Width
25mm 47mm 12mm
💡 Why choose 6005ZZ double shielded deep groove ball bearings for electric motors and light industrial drives?
They balance speed capability, load support, and basic contamination control.
-
Metal shields reduce debris entry without adding seal drag
-
Deep groove geometry handles radial loads with light axial support
-
Chrome steel races resist wear under continuous rotation
-
Factory grease fill supports reliable operation at moderate RPM
If you need a solid bulk set for replacements or new builds, this 10-pack keeps your machines rolling smooth without slowing you down.
I used these to replace 6005Z bearing on a 3 point finish mower's wheels. I was able to remove the shield on one side of the ZZ with a small pick and they were a perfect fit. I was able to purchase 10 of these for the cost of 2 generic ones at my local parts store. I will continue to use VXB Ball Bearing for all my future bearing needs. You can't go wrong with these
I used these bearings to replace roller bearings on a vertical panel saw. The cost from the manufacturer would have been $1800. I got the job done with this product for under $100