Tough As Nails Pneumatic Punch Press Machine With Crisp Digital Display Controller And No Sweat Adjustable Stroke For Dead On Sheet Metal Hole Punching And Quick Milling Jobs
✔️ Single pack holds 5000 kg force 110 v voltage controls
This single pneumatic punch station arrives fully assembled. Workers drop it on benches at machine shops and repair bays to drive holes through aluminum or mild steel quickly. Hobbyists and commercial fabricators appreciate the straightforward layout.
✅ boosted cylinder covers 100 mm / 3.94 inch along the shaft ✅ blank die opening sits at 2.5 cm / 0.98 inch for clean cuts ✅ clamp grip spans an inner gap of 2.5 cm / 0.98 inch wide ✅ table plate covers 46 cm by 30 cm / 18.1 inch by 11.8 inch total surface💡 What features define a reliable pneumatic punch press for industrial hole drilling. You want a unit that delivers consistent strike force without complex wiring. A built in meter shows your set points so you never guess again. Rugged guide rods keep the ram aligned during rapid tapping. Stick with a system that accepts standard shop air to keep things handy on the floor.
- Heavy duty steel chassis reduces bounce during impact loads
- Digital interface tracks cycle counts and adjusts pressure levels
- Compatibility with foot pedals or hand buttons for hands free setups
- Rated for 0.5 to 0.8 MPa compressor output to match most garages