Stainless Steel Chimney Support Bracket Kit With Battle Tested Roof Brace For Pellet Stove And Water Heater Vent Four Seven Five Inch Diameter Heavy Duty Weather Resistant Mounting Hardware No Sweat Install

Heavy Duty Stainless Steel Chimney Pipe Complete Support Kit
✔️ Holds 76 to 254 mm tubes via 47 inch 120 cm adjustable bracket

This heavy duty chimney bracket kit secures pellet stove and water heater exhaust lines against gale force winds and ice buildup. Handy homeowners bolt it to decking or siding to keep vertical flues straight and stop dangerous sagging during peak heating months.

✅ Mess free ten minute assembly arrives with every necessary screw for wall or roof mounting
✅ Flexible ring shape embraces tube widths from three point one eight inches 79 mm up to ten inches 254 mm
✅ Solid stainless build fights salt spray and freezing rain so it never flakes out
✅ Trustworthy anchor point for gas furnaces oil tanks storm gutters or shed chimneys

💡 Where should you place supports along a long vertical stove pipe run to prevent bowing Smart placement saves your insulation and keeps draft strong when the chill sets in. - Anchor main legs at floor level and repeat every four feet 120 cm going up the roof
- Lock clamps onto structural beams rather than thin shingles to carry the dead load
- Apply anti seize lubricant on threads so the hardware stays snugged through freeze thaw cycles

✝️