SMA Pigtail Cable Bare Wire Open End Coaxial RG316 For RF Test And Antenna Extension, PCB Welding Ready, 0.8M Each, 2 Pack, SMA Male Connectors, Two Piece Set
✔️ 2x SMA to bare wire RG316, 0.8m each, 50Ω, 0-3GHz
A practical SMA PCB solder cable set designed for RF testing and antenna extensions. Each piece uses RG316 coax with a bare-wire interface on one end and an SMA connector on the other, ready for PCB welding or quick-test setups. This 2-pack is ideal for lab bench testing, antenna work, and RF signal equipment evaluation.
✅ RG316 coax, 50 ohm, low loss up to 3 GHz
✅ 0.8 m length per piece, 2 pieces in pack
✅ SMA male connectors with bare-wire PCB welding-ready interface
✅ Copper with silver plating, durable and heat-resistant jacket
✅ Shielded design minimizes clutter during testing
💡 What is a handy way to choose an SMA pigtail coax cable for RF test and antenna extension? This quick guide helps you pick the right one for your setup.
- Check impedance: 50 ohm to match RF gear
- Confirm length and connector type: SMA male on the PCB side for board tests, 0.8 m length fits many benches
- Look for RG316 for low-loss performance up to 3 GHz