Quarter Turn Roof Fastener Kit Compatible With Maverick X3 Featuring Heavy Duty Steel Bolts Secure Wing Nuts And Twist Lock Clamps Replace OEM 250100186 Built Tough As Nails For Backroad Runs

Heavy Duty Quarter Turn Roof Fastener Kit For UTVs
✔️ Steel bolts, wing nuts, twist lock clamps replace OEM 250100186 kit

This quarter turn roof fastener set replaces the original CanAm hardware on Maverick X3 models, giving you a dead-solid mounting spot for soft tops and hard roofs during summer sessions. Sold as a single complete service kit, it swaps out stripped or bent fittings quicker than swapping tires so your canopy stays locked down while kicking up red dirt or crawling over rocky washouts.

✅ Direct replacement part number 715003815 fits factory mounting points without extra mods
✅ Heavy duty steel construction handles vibration from backroads and washboard trails
✅ Quick release twist design lets you swap roof accessories in under two minutes flat
✅ Preapplied locking compound resists loose fittings after months of dusty offroading

💡 How do you properly seat these utility task vehicle roof clips without stripping the threads?
You just need a steady grip and a basic metric wrench set since the studs aim straight for the factory rail channels.
- Real handy eight millimeter sockets clear the hex bases without scuffing the zinc coat
- Spin the wing locks by hand until they bite the steel frame then crank an extra quarter turn for a rock hard trail hold
- Wipe the channel grooves clean so fresh grit never messes up your quick swap routine

✝️