LOschten 1700W Desktop Electric Hydraulic Rebar Bender Zero To 180 Degrees Bends Up To Inch Eight Steel Rod Six To Twenty Five Millimeters Fast One Third Second Operation Heavy Duty Construction Tool

Electric Hydraulic Rebar Bender For Steel Bars And Rods
✔️ 1700W motor handles 6 to 25 mm rods bending up to 180 degrees

This single electric hydraulic rebar bender is built for contractors and fabricators who need reliable shaping of reinforcement on active job sites or steady workshop layouts. It takes typical Grade 60 carbon steel bars and threaded rods while keeping operator strain low thanks to an adjustable standing platform that matches most bench heights.

✅ 1700W pure copper coil motor runs 110V or 220V with quiet operation
✅ Adjustable angle knobs lock securely from zero to 180 degrees for repeat cuts
✅ Cast iron frame and hardened drive wheels resist wear during daily use
✅ Quick swap module kit targets precise ninety degree bends on thin six millimeter stock

💡 How do you maintain consistent tolerance when sizing reinforced steel bars?

Matching the drive wheel torque to the steel hardness prevents gear stripping. Here is how you set it up properly: - Set the sliding stops flush against the die face to lock in exact bend geometry - Calibrate the copper coil motor load to match local grid voltage ratings - Keep a digital protractor handy for verifying ninety degree cuts on structural frames - Lubricate pivot pins regularly to keep mechanical resistance low throughout long runs✝️