Heavy Duty Metal Front And Rear Suspension Arm Steering Cup Hub Carrier Set For 10th Scale RC Cars Compatible With PTG2 Platform Rad Beefy Upgrade Kit In Bright Red

Steel Suspension Cups And Control Arms For 1/10 Track Runs
✔️ Powder coated finish mounts directly to PTG2 chassis platforms

This complete four piece upgrade set swaps out fragile factory plastics on trail trucks and short course rigs built around the PTG2 chassis layout. Drivers install these robust carrier components to stop wheel shake, boost ground clearance, and keep steering tight over rocky obstacles and muddy berms.

✅ Anodized aluminum alloy body handles heavy impacts without bending
✅ Sealed radial bearings spin freely and cut down on maintenance hours
✅ Precision machined bolt holes drop right onto ready to run frames
✅ Vivid red coating resists chipping after repeated field washouts

💡 How do reinforced hub carrier assemblies improve grip settings on 1/10 scale rock crawlers?

Solid bearing blocks lock your axle lines tight so power shoots straight to the dirt instead of getting eaten up by slop.

- Machined raceways eliminate lateral play and keep your tracking dialed during hard rock rolls

- Grease filled seals trap lubrication away from grit and mud for longer service spans

Direct fit geometry matches stock pivot points so you skip extra spacers and stay handy on crowded weekend events

✝️