Heavy Duty Hydraulic Power Unit With A Badass Three Phase 415 Volt Motor Pumping Seven To Eighteen Liters Per Minute For Drop Dead Simple Custom Machine Setup And Smooth Daily Industrial Ops

Industrial Hydraulic Power Station For Machine Work
✔️ 3 phase 415v motor pushes 7 to 18 liters per minute smoothly

This single heavy duty hydraulic power pack drops straight onto any workbench or steel frame to feed cylinders and actuators. Shop techs mount it vertically or horizontally to tame press tables, lift gates, and custom automation rigs without hunting for separate motors or reservoir tanks.

✅ 750 watt sealed pump handles 16 up to 20 mpa working pressure consistently
✅ G 1/2 inch bsp npt threaded ports snap directly into standard hydraulic lines
✅ 60 by 50 by 40 cm shell fits tight corners without eating up valuable floor space
✅ 65 kilogram cast iron base absorbs vibration during heavy press cycles
✅ Custom colored reservoir lets teams label units by zone or shift schedule

💡 Why choose a direct drive hydraulic power pack for busy fabrication shops?
Kicking off reliable fluid movement stops guesswork when you are rigging jigs or rebuilding aging machinery. Matching amp draw to your panel breaks avoids costly breaker trips.
- Internal heat exchange loops run cool even when you cycle the system nonstop
- Bleeder ports sit right where you need them so air escapes fast and sticks pull smooth
- Quick disconnect fittings slide easily during filter swaps so downtime stays short