Four Pack Three Quarter To Five Eighth Inch Misalignment Spacer Heims Rod End Bearings For Slick Control Arm Adjustment And Tight Linkage Setup That Gonna Keep Your Build Running Sweet

Fitment Heims Spacer Bearings For Steering Linkage
✔️ Corrects angular gap in heavy duty linkage assemblies fast

This set of four conversion spacers bridges the gap between three quarter and five eighth inch rod ends. You can mount these directly onto axle shafts, tie rods, or control arm brackets to dial in precise alignment before heading out on dirt trails.

✅ Four pack quantity for complete axle builds
✅ Adapts three quarter inch fittings down to five eighth inch size
✅ Fixes tilt and binding in rigid suspension geometry
✅ Built for heavy impact loads on street rods and rock crawlers

💡 How do misalignment adapters help rigid rod end joints handle extreme pivot angles?
Swapping fixed pivots usually creates binding when the chassis flexes over rough terrain. These spacer rings serve as a handy fix for loose connections and stressed pivot points.
They keep grease channels aligned so the zerks stay reachable during routine maintenance
They absorb lateral forces that normally snap cheap washers flat under high torque loads
You can fine tune tracking geometry without drilling fresh holes in sturdy frame rails